So this is a major pain in the neck if you don’t understand what is going on.
With Linux and Windows, you can have both drivers installed with no problems”. You can only have one driver installed at a time. According to a FTDI FAE: “With Mac OS X, our VCP and D2XX drivers are mutually exclusive. FTDI has two different drivers available for their chips which can cause a problem on OS X systems. FT2232D/C/L - Dual High Speed USB to UART/FIFO FT232B – Single USB to UART Converter ICs Most support arbitrary baud rates, so non-standard baud rates, like 3030 baud (used by Lionel) or 10417 baud (for the automotive LIN bus, see SAE specification J2602) are obtainable. A Maxim MAX232, is required to interface to a RS232 or other interface that uses different signal levels.įTDI (Future Technology Devices International) produces several chips: FT232H - Single Channel High Speed USB to Multipurpose UART/FIFO IC FT2232H - Hi-Speed USB 2.0 - Dual UART/FIFO /I2C/SPI/JTAG IC up to 12 megabaud FT4232H - Hi-Speed USB 2.0 - Quad UART Converter FT232R – Single USB 2.0 to Serial UART Converter IC. Most of the USB to serial converter chipsets deliver 3.3V or 5V TTL level signals and an additional converter chip between signal levels usually called a Line Driver/Receiver, e.g. Update your computer's drivers using DriverMax, the free driver update tool - Multi Port Serial - Texas Instruments - TUSB3410 Computer Driver Updates. Below is some information on some of the USB to RS-232 adapters I am aware of. This page isn’t intended to discuss the end user USB products for adding a RS-232 port to your Macintosh, but much of the information below applies to them. There are several devices on the market to bridge the gap from a serial port (UART, SCI.) on your MCU to the USB bus.
0 kommentar(er)
